Nitto RB Series Crankshaft Collar Fits Early R32 GTR RB26, All RB20, RB25 & RB30

NITTOs RB series crankshaft collar was specifically developed to be used on RB series crankshafts that have the factory narrow oil pump drive on the crankshaft snout.

Most earlier RB series engines have crankshafts with the narrow oil pump drive. This becomes a major problem when upgrading your oil pump to the commonly used wider gear type pumps as the contact area from the drive to the oil pump gear was minimal. This caused either the drive to wear out prematurely or excessive force to be applied onto a small area of the oil pump gear and cause eventual oil pump failure followed by major engine failure.

NITTO offers an affordable solution to this problem by designing a high tensile 709 series steel RB series crank collar with a full width contact area compatible with any replacement oil pump. This ensures the correct contact area needed to safely run you engine at high rpm and minimizes the possibility of premature oil pump failure due to a poor contact area.

For Use With High Volume Oil Pump (Nitto, Tomei, Genuine R33/R34 RB26 & N1)

Vehicle Compatibility:

– Nissan Early R32 GTR RB26
– Nissan RB20
– Nissan RB25
– Nissan / Holden RB30